waja 1.6 manual gear box
Posted 03 April 2008 - 09:45 PM
recently my waja gear box seem like got some problem. every time when
shifting gear 2 to 3 or 3 to 4 will got a klok klok sound coming out from
engine bay. and quite hard to shift gear. i dunno what happen then i go to
proton service centre trying to solve the problem. the foreman there also
trying to help me solve it, but finally they tell me the sound come inside
gear box,tell me what maybe gear shaft problem(maybe). then cant help me.
but he advise me to buy a gear box easier..
may i know how much cost a recon waja 1.6 manual gear box at those kedai
potong?? or any place in JB can help me solve this type problem??
i try changing the whole clutch kits, gear oil but all no uses....
Posted 04 April 2008 - 10:58 AM
Posted 04 April 2008 - 08:53 PM
If gear shift cable will make this kind problem?? got a klok klok klik
klik sound when shifting gear.
my car really make me headache....keep facing problem with it!!
should i change a car better?? anyway,any people know how much a gear box
Posted 04 April 2008 - 11:46 PM
black with dirt. These guys can strip your gearbox, check every part and
fix if fixable.
I've seen a gearbox being taken apart and it's not easy and very time
consuming. Is there a opening (covered by a rubber boot) somewhere on the
box? Usually, spraying some lube into it helps sort out the noise.
But before doing that, when was the last time u had your gear oil drained
and changed? Try changing the oil and add in some gear additive such as
WYNN Gear Treatment. This thing will smoothen your gear change.
Posted 05 April 2008 - 08:30 PM
the oil for more than 4 times already. and also add in the gear additive
alrady. but no use with that.
the sc people tell me waja hardly got this kind gear box problem. dunno
why i am so lucky...
i really gonna give up my waja already! keep problem here, problem there.
Posted 12 April 2008 - 11:41 PM
from the plate. The gears shifting was quite difficult. As mentioned i
went to dirty foreman and dismantled gearbox. Finally changed to original
Mits. clutch set i.e. Clutch plate, Pressure plate & bearings. All ok
till now almost 300k km. this happened at about 65K km. Hope this would
give you a possible cause for dismantling the clutch set. Mine installed
originally by Proton was Exedy.... i never trust exedy again.
Posted 16 April 2008 - 07:35 PM
to change timing belt soon.