bro... u so un romantic.... so straight to the point....
well, it is a pain if stuck in traffic jam..... the clutch like very heavy leh. Even my trooper have a lighter cluth.
back to topic, possible to install roll bar inside without removing rear seats??
if a single rollbar in the middle (B-pillar) no need to remove any seats...just some side panel need to be moved abit (or not at all).....but iff full bolt-on rollcage sure have to remove seats first to reach mounting point...
one more Question, when i first start up the GTI in the morning, i need to press the accelerator kuat kuat (rpm high - 1st gear and reverse gear) to move the car, otherwise, the engine like want to stall.....
when the car warm up, no such problems.
what could be the problems?
this one sounds like familiar throttle body problems....try service the TB first and check all related parts..(mostly idle controller unit melted)