Changed absorber, changed absorber link.. finally changed the stabaliser bar bush cost RM15 for 2 pcs and labour is RM70. Quite difficult to reach this 2 bush. Nearly 1 hr.
Close
Sound Going Up And Down Speed Bumps
Started by
mych
, Jan 07 2015 08:17 PM, 4 replies to this topic
#2
Posted 07 January 2015 - 10:42 PM
QUOTE (mych @ Jan 7 2015, 08:17 PM) <{POST_SNAPBACK}>
Changed absorber, changed absorber link.. finally changed the stabaliser bar bush cost RM15 for 2 pcs and labour is RM70. Quite difficult to reach this 2 bush. Nearly 1 hr.
U diy change arb bush?
Mind sharing the step as i have bought the bush last time but cant reach it.end up losing the new bush.
anyway nice to see another loyal waja owner.i think u have been in waja forum since i join aw.
#3
Posted 08 January 2015 - 10:17 PM
Just posting issues so that I don't forget.. that cheap bush causing the noise not the others.. now it is pretty quiet going up/down humps at 30 km/hr..
Car still good condition with proper maintenance.. parts cheap.. hard to find a reason to dump the ride after the HP repayment is finished ..
Car still good condition with proper maintenance.. parts cheap.. hard to find a reason to dump the ride after the HP repayment is finished ..
Mych
#4
Posted 08 January 2015 - 10:20 PM
QUOTE (Gunnerzz @ Jan 7 2015, 10:42 PM) <{POST_SNAPBACK}>
U diy change arb bush?
Mind sharing the step as i have bought the bush last time but cant reach it.end up losing the new bush.
anyway nice to see another loyal waja owner.i think u have been in waja forum since i join aw.
Mind sharing the step as i have bought the bush last time but cant reach it.end up losing the new bush.
anyway nice to see another loyal waja owner.i think u have been in waja forum since i join aw.
the sbsorber link bush is situated deep in between the lower arm chassis.. i don't think can DIY safely .. the mechanic has a hoist and noticed he had to dismantle both tyre and numerous other screws with the air gun.. even the center member was taken out in the process..
Mych
#5
Posted 09 January 2015 - 07:15 PM
QUOTE (mych @ Jan 8 2015, 10:20 PM) <{POST_SNAPBACK}>
the sbsorber link bush is situated deep in between the lower arm chassis.. i don't think can DIY safely .. the mechanic has a hoist and noticed he had to dismantle both tyre and numerous other screws with the air gun.. even the center member was taken out in the process..
Thats what i tot but when i can see the bolt holding the the clamp which held the bush in place,i tot i can reach it.