[official] Proton Exora Bold And Prime

Bro ntc got sooo much free time...hehe
Bro,i belief all guys here wants to see yr chrome piping lah....post some pic pls...

That insulator u bought can be used to wrap the aircond pipe.i did that on the waja,pajero,kenari,blm.
If helps cool the aircond quicker and compressor wilk runs on lesser. Hence a tad saving in fc which means u can go mad with the throttle more often.
Just remember to only wrap the cold line.
Btw u are going to need a set of very flexible finger at some part.
Best thing i saw in above pic is the snow mat....hehehe
Seriously, it helps cleaning the carpet easier.

That t10 led, i dont advise unguys to buy it at car acc shop as the price is ridiculus,crazy, potong kepala.
Go to bike shop and ask.....i know2....stop gawking...its a hell lot cheaper there.

Bro ntc,that leather needs a conditioner fast as its not of the same quality as they installed in the v6 and waja.
Turtle wax does the job just fine.

Bro ntc,
That aftermarket fuse holder on the battery, what gadget did u install?

i wrap it with aircond insulator alr... long time ago... wrap the bigger pipe is for cold line.

T10, i bought RM9.90 for pcb board LED which come with 16SMD.

that 1 I add another pair for BM horn...

original only 1 BM horn, then I add in another 1 pair to make it louder.

sorry mate for interrupting, a bit off here.
id like to ask weather any exora owner do have an issue of steering vibration at 110-120 provided that both front is ni perfect balanced (3x at the wheel shop). well i met the sc advisor and they are willing to check it next week. i do found another owner reporting for the same matter.
so if any of u guys did come across this, ill be glad to hear how the sc solve this problem if any..

and for the wind noise at the driver's side when driving at 80kmh. i have sort this out by diy easily. no more wind noise.

as well as cigarette lighter socket kaput simply caused by a middle lower (15amp) fuse replacement.

exore b cfe is a very good car. hope to solve the steering vibes for exora b to get 100/100 full marks.

Hi Bro, possible to share what DIY you did to get rid of the Wind noise? Regards

bro, its easy.
1 fold the mirror
2 after its folded u can feel the hole or cavity underneath it that now its exposed as it is folded position.
3 fill up the holes or cavity with sponge or anything that can act like fillers ,myself i use small piece of paper but u can us batter material.
4. unfold it thus the mirror ,the fillers then will stay secure. unless you have the auto-fold of H-spec ,the filler need to tight or holds so that it wont drop off during auto-fold.
5. drive off at 80kmh,
6. come back to this forum for a testimony.

ok bro thats all, happy trying.

Thanks Bro for the sharing, last time I tried pasting a tape to cover the Slot but still it didn't solve the problem completely.
Maybe it was not fully covered . I saw in another forum a member using Felt to paste inside the Slot.
I also bought the Felt but I saw the slot is too small so cannot simply paste like that.
Need to see how to do it. Will share after that... Thanks.

plasticine maybe works.
or aquarium sealer.

so,today i went to service center for a service also reporting about steering vibration,
because of 2 times performing on wheel balancing at tire shop. and it doesnt work.

but proton say . lets have 4 wheels off and put it on their new machine in service center (off wheels balancing).
after all were done , i drove the car 110 120 130, ....play around at that speed, it cured ,but still a little some giggle at 120.

Hi,
Have any of us experience the following:
1) When the car is slowing down (release the pedal), and u press on the pedal again will actually make the car shake or hesitate a bit, before the car is gaining power to continue.
2) When the car is slowing down (release the pedal) and to a near complete stop, and u press the pedal to continue, the engine dies off. This is especially true when going up a slope.
3) During slow speed, like parking the car, forward and reverse the car without complete stop, but at a very very slow forward speed and make the engine dies off. Even if it is not, you will experience a "cough" feeling from the engine.

I have been complaining this to the SC every time i visit them. The have update the software and changed the OCV still not solving any of the above....