Ssangyong Rexton Hub

Hi Bro,


Bro how much they cost for replace the bearing..? because i just bought the NTN 32008X for front wheel bearing, as i know SC charge for rm4xx plus for one side, outside machenic cost rm210 one side.

This is the same case today.. a white Alphard keep tailing me at 120kmh and the left lane is full, so no chance to give way to him. My Rexton is full load with 5 adults + 3 kids + luggages, plus in law on board, so must behave on road. When reaching Sgi Perak stretch with slight climb, just release fuel pedal awhile and then fully floor it with a thick black smoke bombing the Alphard and accelerate to 140kmh climbing leaving him behind in thick black smoke. He can't even accelerate to catch up with me... hehehe..

Now the black smoke is good defensive weapon against those who like to tail your backside, you can really smoke him and the black smoke is really thick blocking his good view.

Hehehe.. wait if his injectors really clogged up, it must be your curse then



Hahahah!! bro ,

Actually! he suspected by him self for injector clog up, and also the fuel filter, because the engine check light appearance! as for today! when full throttle at the NKVE highway, engine check light appeared again, higher the speed which will require higher the fuel supply or flow rate.

Hi rx270xdi,

2 bearing cost me RM84, i buy it myself ( i'll PM you the company address )..plus change the engine oil, change coolant,change power steering oil, check the brake pad, replace the bulb, check the gear oil..everything the labour only RM60-00

NIK

the humming come from below the car and I can feel a slight vibration when the speed reach 70km/h. have you tested with the window down?

Petronas Urania CJ-4 feel the same like previous oil, maybe after 5000 km or...I'll check the milage to see if any improvement later this week.

but changing the power steering oil does give some improvement, much smoother and lighter than before.

hey...1400km...you really raya than me..hihihi

NIK

Thanks Bro,

As i know the original wheel bearing is KSB from Korea, same factory as FAG, and how you find the bearing numbers..? 32009..? by actual bearing take out from your wheel..? because i only manage to find 32008, i tot both bearing is the same size.

That company is my regular supplier at PJ, but they don't have FAG, or the NTN. i bought the NTN 32008X from others supplier, coat me rm2x over to rm30 for the NTN 32008X. If rm84 you can get from Hankok at Rawang, with the oil seal as well.

2300cc is about RM680-00.

http://www.cars-data...6123/specs.html

average about 12.3l per 100km or RM22.75...RM0.227/km

ha ha ha ha, especially those just come out from car wash sure don't want to follow behind

Under 100kmh, very quiet. Have not thought of testing with window down, will try tomorow. My engine oil coming 5,000 km soon, can feel engine heavier when after running long distance. Maybe the service center did not use CI-4 during previous change. Will try out CJ-4 during next change.

I Raya 10 days mah, more like tour van driver la hehehe...