1. Side view mirror hit by a reckless motorcyclist.
2. Purchased a side view mirror replacement (part number 96545753, Made by GM Korea) for RM31.40.
Note : 8 clips and the heating elements
3. Tilt the side mirror outward and to its lowest position so that there's a good amount of space between the mirror and the housing in its upper right corner. Insert a rag through the gap to prevent the housing from being damaged by whatever tool you choose to pry the mirror out with. Insert the tool through the gap towards the center and pry open the top clips.
4. Once the tops clips are pryed open, gently remove the broken mirror from the housing.
5. Disconnect the two wires from the mirror by holding on to the heat shrink tubing and pull it out.
6. Side view mirror housing without the mirror.
7.Remember to connect the wires to the new mirror. Tilt the replacement mirror to snap the lower clips in first. Check the alignment before snapping in the top clips. Hold the bottom half in position while pushing the top half into place. You will hear a âclickâ sound once the top clips are snapped into place.
Close
Diy - Replacing Side View Mirror Glass For Chevrolet Optra 1.8lt
Started by
bloptra18
, Mar 17 2009 02:08 PM, 5 replies to this topic
#2
Posted 11 September 2009 - 05:43 PM
Thanks for the very detailed DIY. I was searching for one and then,luckily, I found your post. Thanks, thanks.
Anyway, I also want to inquire if Kool View is a good brand. I saw this replacement mirror glass.What do you think about it?Thanks in advance for your reply.
Anyway, I also want to inquire if Kool View is a good brand. I saw this replacement mirror glass.What do you think about it?Thanks in advance for your reply.
#3
Posted 21 September 2009 - 11:56 PM
QUOTE (ema @ Sep 11 2009, 05:43 PM) <{POST_SNAPBACK}>
Thanks for the very detailed DIY. I was searching for one and then,luckily, I found your post. Thanks, thanks.
Anyway, I also want to inquire if Kool View is a good brand. I saw this replacement mirror glass.What do you think about it?Thanks in advance for your reply.
Anyway, I also want to inquire if Kool View is a good brand. I saw this replacement mirror glass.What do you think about it?Thanks in advance for your reply.
I'm glad you find the DIY helpful.
I do not know about Kool View. If I were you I'll get the original replacement glass from the local SC. Cost RM31+ consider cheap if your compare with Toyota's which you may pay 3 to 4 times more for a replacement mirror glass. Getting Chevy replacement part will guarantee to fit.
Make sure you get the correct one. For the 1.6 its mirror does not have the heating elements
#4
Posted 02 October 2009 - 07:55 AM
QUOTE (bloptra18 @ Sep 21 2009, 11:56 PM) <{POST_SNAPBACK}>
I'm glad you find the DIY helpful.
I do not know about Kool View. If I were you I'll get the original replacement glass from the local SC. Cost RM31+ consider cheap if your compare with Toyota's which you may pay 3 to 4 times more for a replacement mirror glass. Getting Chevy replacement part will guarantee to fit.
Make sure you get the correct one. For the 1.6 its mirror does not have the heating elements
I do not know about Kool View. If I were you I'll get the original replacement glass from the local SC. Cost RM31+ consider cheap if your compare with Toyota's which you may pay 3 to 4 times more for a replacement mirror glass. Getting Chevy replacement part will guarantee to fit.
Make sure you get the correct one. For the 1.6 its mirror does not have the heating elements
Thanks mate. Very informative
#5
Posted 04 February 2010 - 01:32 AM
Here in SG, a piece of mirror cost S$43.87. Got mine replaced as it cracked too.
QUOTE (arif_yusof @ Oct 2 2009, 07:55 AM) <{POST_SNAPBACK}>
Thanks mate. Very informative
#6
Posted 05 July 2010 - 11:57 AM
Very informative stuff. Unfortunately, my prob is not with the mirror itself.
It is with the side mirror folding mechanism (optra 1.8). Chergazam say it will cost over RM700 to replace the whole unit!
Does anyone know if it can be fixed? Or cheaper replacement?
Prob: When it unfolds, it seems the motor doesn't stop, resulting in the mirror give a 'klack' sound and springing back into position. It repeats several times before it finally stops!
Hope my description is clear.
Thanks.
It is with the side mirror folding mechanism (optra 1.8). Chergazam say it will cost over RM700 to replace the whole unit!
Does anyone know if it can be fixed? Or cheaper replacement?
Prob: When it unfolds, it seems the motor doesn't stop, resulting in the mirror give a 'klack' sound and springing back into position. It repeats several times before it finally stops!
Hope my description is clear.
Thanks.