[champion22]

Dear friends:
My Waja 1.6A 2001 45,000km faced with the following problem.
1. When I start the car is OK. Once I engage the gear "engine mati"
especially when I engage the reverse gear.
2. Next when I "tekan minyak", it takes about 8 - 10 seconds to response,
very slow pick up.
3. Left rear tyre area "ngung, ngung" sound when in slow speed.
4. Auto change of gear not smooth at all, and really feel the jerk.
For those who has the same experiene, please assist. Thanks.

[Emanage]

Original Poster : champion22
Original Post : Dear friends:
My Waja 1.6A 2001 45,000km faced with the following problem.
1. When I start the car is OK. Once I engage the gear "engine mati"
especially when I engage the reverse gear.

Air filter got chnage or not ?
throttle body got service or not ?

2. Next when I "tekan minyak", it takes about 8 - 10 seconds to response,
very slow pick up.

Same as above

3. Left rear tyre area "ngung, ngung" sound when in slow speed.

may be tyre nearly botak already

4. Auto change of gear not smooth at all, and really feel the jerk.
For those who has the same experiene, please assist. Thanks.

Every 20k must change gear oil .. Do you get it change ?

[Ray5059]

Normally these are ECU related problems. Check whether your
ECU is wet.

[champion22]

Thanks Ray, appreciate it! I suspect ECU related problem too. Any idea of
how to go about? Should I send it to SC for further inspection. Any
estimate of the charges?

[champion22]

Emanage: Tq. All done as mentioned by you. And the tyre is still good. I
recently change the front tyre to the rear. Two new one in front.

[premium]

hai friend.....try to do flushing at your auto transmission...it is
expensive but the result is excellent....

[champion22]

Premium: What is the estimate of "expensive"? Can any mechanic do it ?

[premium]

Rm 250 to 300....take about 9 to 10 liter of ATF...any EON or PE with the
equipment can do...

[champion22]

Premium....Tq will try it out

[wajaX4288]

champion22,
1. I no comment, look serious only..better check wif mech
2. Same as above
3. This one...hmmm i spend a lot of time hunting high & low for this
noise..even change absorber oso still cannot...still hunting...this
forum u can see a lot waja have this stupid problems...no once can
be certain wat & how to solve it ...not up to today!!
4. Sumtime..my auto oso feel a bit jerk...but only a bitlah...

if u find solution..pls share ok TX