Proton waja
Close
How To Change Timing Belt Proton Waja1.8?
Started by
nickyap
, Jul 13 2013 07:55 PM, 4 replies to this topic
#2
Posted 13 July 2013 - 09:57 PM
QUOTE (nickyap @ Jul 13 2013, 07:55 PM) <{POST_SNAPBACK}>
Proton waja
tedious job.. must ask professional / mech to do it rather than DIY
#3
Posted 20 July 2013 - 04:59 PM
QUOTE (mosh @ Jul 13 2013, 09:57 PM) <{POST_SNAPBACK}>
tedious job.. must ask professional / mech to do it rather than DIY
Its going to be hard for a 1st timer without any detail step.
Just sent it tona mech and observe carefully. Then i know u will say....wah senang je....
Its easy if u know the marking.
Just remember to change the water pump and tensioner to.
Also whiile u r at it, if yr engine have tak2 sound and u dont mind spending quite a high sum, u can have the dephaser pulley change too.
#5
Posted 27 July 2013 - 07:47 PM
QUOTE (mosh @ Jul 25 2013, 12:08 PM) <{POST_SNAPBACK}>
dismantling the crank pulley without powertool is arghhhhhhhhhhhhh! i dont want to do it again
Then its time for an air compressor and some air powered tool.
Last week got sale at malim jaya melaka.
Got 1 small impact,very handy as it can be used within the engine bay.
Price was oso tempting but i already had an impact wrench,just that its a tad bulky.
The tool set which comes with the drawer was also calling my name when i was walking away...
Hehehe
Too bad there are no torque wrench on sale.